Request a quote
Benešl Automation / References / Gebauer & Griller
Case study · Machines and production lines

Control of a circular assembly line with robots and cameras

For Gebauer & Griller Kabeltechnik in Mikulov we delivered the control of a 10-module line: automatic stations, transfer units, communication with robots and camera systems, and production data handover.

line modules
10
automatic stations
5
transfer units
2
TIA Portal
V20

Customer and assignment

Gebauer & Griller Kabeltechnik, spol. s r.o. in Mikulov needed the control of a circular assembly line. Parts travel between the modules on carriers. The line starts and ends at the same module: the operator loads a new part there, and after a full cycle the finished part is scanned, labelled and removed.

What we delivered

  • The PLC program for the whole line in TIA Portal V20, including the safety program.
  • Control of 5 automatic stations and 2 transfer units.
  • Communication with robots and camera systems.
  • Part tracking through the line and handover of part data to the customer's higher-level system.
  • Measurement of individual module times for evaluating and tuning the line cycle time.
  • Step time monitoring: on a fault the step stops, the line reports it with a beacon and on the HMI, and after the operator acknowledges it the step is repeated.
  • A program commented in Czech so the customer's maintenance team can find their way around it.

Safety

The line's safety functions are in the PLC safety program. An emergency stop stops the entire line, and the behaviour of doors, reset and manual mode follows the customer's requirements. We went through the safety functions in a separate review before handover.

Result

The customer has a line with clear fault diagnostics, individual module times for further optimisation and a readable program that their own maintenance team can work with.

What this means for you

  • Measure module and step times from day one of operation. Without them, tuning the cycle time is guesswork.
  • Step time monitoring with clear signalling greatly shortens the search for the cause of a fault.
  • For maintenance, a commented program and consistent names are as important as the function itself.

Planning a new machine or line?

Send us a description of the machine or the line layout. We will propose a control system and estimate the effort.